Looking through my archive I found this image. It is one of my favourite spoons, ever, though, if I were to make another I think I’d carve the stem a little differently. The single heart spoon I posted back in March was developed from this design, although if you compare them you’ll find lots of changes made along the way. I particularly like the flow of the endless knot and the reduction in size of the hearts from bottom to top.
This little distraction occupied much of my spare time from the end of November to late January, and now it has been delivered I can post about it. The lovespoon was completely hand-carved, using a coping-saw to rough it out, then whittled with a knife and a very small shallow gouge; a tiny spoon-bent gouge was used to cut through the links(the heart is completely free to move around but the intertwining knot-work stops it from falling out). The only other tool used was a medium spoon-bent gouge for the bowl. I hate sanding and put it off until there is no alternative – the tool marks were smoothed down by scraping with the knife-edge held vertically – any remaining marks were smoothed off with a 400-grit abrasive mesh. Ironically, the wood was almost too smooth and the paraffin-wax finish needed warming up gently to make it more sticky as it just slipped off the wood in some places.