Looking through my archive I found this image. It is one of my favourite spoons, ever, though, if I were to make another I think I’d carve the stem a little differently. The single heart spoon I posted back in March was developed from this design, although if you compare them you’ll find lots of changes made along the way. I particularly like the flow of the endless knot and the reduction in size of the hearts from bottom to top.
This was my most recent commission, a wedding gift for the groom from his bride. The photo doesn’t do it justice at all. The biggest challenge was the water-lily as I’d never carved one before but it all turned out very nicely. The mahogany threw up a few challenges as it can be prone to splitting. The ship’s wheel is fore-shortened in the photo as it is carved on an angle. The top half of the spoon is actually the same length as the heart/stem/bowl. The underside of the flower is fully carved also, with the tendrils forming a never-ending knot and holding onto the horse-shoe that forms the top of the heart-lock
This little distraction occupied much of my spare time from the end of November to late January, and now it has been delivered I can post about it. The lovespoon was completely hand-carved, using a coping-saw to rough it out, then whittled with a knife and a very small shallow gouge; a tiny spoon-bent gouge was used to cut through the links(the heart is completely free to move around but the intertwining knot-work stops it from falling out). The only other tool used was a medium spoon-bent gouge for the bowl. I hate sanding and put it off until there is no alternative – the tool marks were smoothed down by scraping with the knife-edge held vertically – any remaining marks were smoothed off with a 400-grit abrasive mesh. Ironically, the wood was almost too smooth and the paraffin-wax finish needed warming up gently to make it more sticky as it just slipped off the wood in some places.